1 S2.0 S0263876209000707 Gr6

Particle injection

Particles can be injected from the walls, inlet, outlet, and opening to the domain of solution. The following information should be adjusted to determine the injection of the particle:

  • Particle velocity: They can be equal to continuous phase velocity by CEL.
  • Injection zone
  • Number of position of the particles
  • Mass flow rate for all injected particles: Particle mass flow is required for full coupling analysis, but for single-sided analysis, it is only used in post processing.
  • Particle diameter distribution: can be set in the MORPHOLOGY history section, however, if the same amount of distribution has been used for all boundaries.

 

Mr CFD Company services

Due to the wide range of mechanical science and the different fields of work as well as the abundance of projects, this company offers to view all the products presented in this section. In the absence of any desired project or project close to your request, you can search our portfolios in order to find your eligible project, after all, if you didn’t find any ideal project you can order your project from the services pages on the header of this website. Your order will be reviewed by our experts in the shortest possible time, and if we need more information about the proposed project, we will be in touch with you. After completing the required information to examine the proposed project, and confirming your request, the time, conditions and costs will be sent to you during the contract. This process will take place as soon as possible. If you have any question, you can contact to our online support section (the fixed blue tab below the page). If it is offline, don’t worry, you can post your message, and it will be answered as soon as possible.

Leave a Reply

Your email address will not be published. Required fields are marked *

Call On WhatsApp
Search