Discrete Phase Model (DPM): Diameter Distribution

Introduction to DPM Diameter Distribution

In Ansys Fluent software, five interpolation methods are available to determine the size of DPM particles, including linear, uniform, rosin-rammler, rosin rammler logarithmic and tabulated. In this article, we aim to investigate each specification and its limitations.

Linear Diameter Distribution

This model can only be used with group injection type. First, we determine the diameter of the starting and ending point. If both points have the same diameter value, the diameter distributions will be the same for all particles. However, if these two points have different values, the diameter distributions will change linearly.

Diameter DistributionUniform Diameter Distribution

This model can be used with surface and volume injections only. Although assuming a single diameter for all particles is not correct, with a simple simplification assumption, it is employed in most engineering projects. It assumes all drops with the same initial diameter.

Diameter Distribution

Rosin-Rammler Diameter Distribution

A good representation of the droplet size distribution is the expression Rosin-Rammler. The full range of sizes divides into a sufficient number of discrete distances. Each represents an average diameter for which the path calculations perform. We calculate the mass fraction using the following expression:

Equ

Where n is the size distribution parameter presented as the spread parameter, and d ̅ is the size constant.

If the diameter distribution is between 0 and 200, The mass fraction expresses as follows:

11 1

The total mass fraction is equal to 1 or 100%.

Also, according to the diagram below obtained from solving the Rosin Rammler equation, we see that it has good accuracy according to the experimental data:

Diameter Distribution

The figure below shows the Rosin-Rammler input data:

Diameter Distribution

Rosin Rammler Logarithmic

This method solves the Rosin Rammler Diameter Distribution logarithmically, which increases the accuracy of the problem and, consequently, the computational cost.

Tabulated 

This model is only used with cone and surface injection types. You need to use a text file in which diameter distributions are sorted in a tabular form. Three parameters should be set: representative particle size, number fraction and mass fraction.

This Post Has 0 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top
Search
Whatsapp Call On WhatsApp